From the manual (my additions in parenthesis):
Always wind the bobbin before threading the machine and needle.
- push in indent on hand wheel disc (right hand side of the machine). This will stop the needle from moving.
- place spool of thread on spool pin (top of machine)
- slide spool cap firmly over rim of spool to prevent thread tangling.
- lead thread from spool and snap into thread guide post (top of machine, plastic)
- wind thread clockwise around front of bobbin winder tension disc (top of machine, metal, left front)
- pass thread end, from inside, through small hole in rim of bobbin
- place bobbin on spindle (top of machine, metal, right front) and push it to the right
- holding thread end, step on speed controller to run machine until desired amount of thread is wound - winding stops automatically once bobbin is full
- cut thread, push bobbin to the left and remove it from spindle
- trim thread from top of bobbin
- return hand wheel disc to sewing position by pressing on side opposite indent
Always wind the bobbin before threading the machine and needle.
- push in indent on hand wheel disc (right hand side of the machine). This will stop the needle from moving.
- place spool of thread on spool pin (top of machine)
- slide spool cap firmly over rim of spool to prevent thread tangling.
- lead thread from spool and snap into thread guide post (top of machine, plastic)
- wind thread clockwise around front of bobbin winder tension disc (top of machine, metal, left front)
- pass thread end, from inside, through small hole in rim of bobbin
- place bobbin on spindle (top of machine, metal, right front) and push it to the right
- holding thread end, step on speed controller to run machine until desired amount of thread is wound - winding stops automatically once bobbin is full
- cut thread, push bobbin to the left and remove it from spindle
- trim thread from top of bobbin
- return hand wheel disc to sewing position by pressing on side opposite indent